
Phones answered 7am to 5pm
Hot water replacement in Ngunnawal: scope restricted equipment access Hot water system replacement.
We take the old one out and fit one that suits how your house uses hot water.
- Call back in 5 minutes
- Same day visits
- 10% off when you book online
- Rated 5.0 on Google
- Licensed in the ACT and NSW
- Homes, rentals and businesses
★★★★★
“Friendly … and respectful of making a worksite in your home”Sue M · Google review★★★★★
“Arrived on time … and left everything clean and tidy”Talia · Google review★★★★★
“Arrived when they said they would”Alessia · Google review★★★★★
“Quick to respond, efficient … reasonably priced”Christine · Google review
Still putting up with these?
The old tank is rusty and leaking at the base.
We take it out and fit a new one.
It's been patched up again and again.
We tell you when a new one makes more sense.
The old unit sits in a tight spot.
We plan how it comes out before the day.
Hot water system replacement in Ngunnawal
Ngunnawal unit changeovers: distinguish removal access, connection work and fixed-surface preparation before agreeing installation.
Frost, pipe runs and Ngunnawal hot water units
Ngunnawal was gazetted on 24 April 1992, and its winters bring regular frost. The long-running Canberra Airport Comparison station averaged 94.1 days a year with a ground minimum at or below -1°C (BoM, 1940 to 2010), and the current Canberra Airport station records 92.4 days a year at or below 2°C. Where a Ngunnawal unit sits in a tight side passage or behind a fence, the pipework to and from it still needs attention, and the ACT Government advises insulating all hot water pipes and storage tanks to cut hot water energy use.
Tempering valves in a Ngunnawal changeover
Households in Ngunnawal averaged 2.6 people at the 2021 Census, and the bathroom is where the hot water temperature rule applies. Under the Plumbing Code of Australia, heated water at each bathroom sanitary fixture in a home is capped at 50°C. A tempering valve is one way to meet it; the NCC also accepts a thermostatic mixing valve, a thermostatically controlled tap, or a water heater marked as limited to 50°C. On a changeover with restricted access, where that valve sits is worth settling before the old unit comes out.
Here's how it works.

Give us a call.
Call or send the form. A photo of the label on your old unit helps.
Step 1: Give us a call.
When this service is useful
A full replacement may be appropriate for a deteriorated, leaking or unsuitable unit. The decision should consider the current fault, realistic repair options and demand at the property. Oroflow supplies and replaces electric and continuous-flow hot water systems.
Compare like-for-like quotes
Ask what supply, installation and removal include and what needs inspection first. Timing and availability must be confirmed for the actual job. No fixed replacement price, brand availability or blanket warranty length is advertised.

We come to you.
We check the old unit, the space and how it comes out.
Step 2: We come to you.
Specify the complete changeover
Discuss system selection, safe access, removal of the existing unit, plumbing connections and any other trade coordination. Explain household or commercial use and simultaneous demand. Do not assume the old unit size remains the best fit.
Replacing a gas unit in Canberra
A Canberra home with a gas meter already installed can keep using its gas connection. The ban that started on 8 December 2023 stops new connections, not existing ones. So a failed gas unit raises a real choice rather than forcing one. The ACT Government says hot water heat pumps use 55 to 80% less energy than standard electric storage or gas systems. It also says they work well in the ACT’s cold climate. Its estimate is that moving from gas hot water to an electric heat pump can cut around 10 tonnes of emissions over the heat pump’s life. If you plan to remove the gas meter later, remember it cannot be reconnected once abolished.

We swap it.
The old unit goes out, the new one goes in and gets tested.
Step 3: We swap it.
Changeover paperwork in Bungendore and Braidwood
Swapping out an existing hot water system is classed as minor plumbing work in NSW. A Notice of Work does not need to be lodged before it starts. The Combined Notice of Work and Certificate of Compliance form can be used instead. Whoever arranged the job should receive a copy of the Certificate of Compliance at the end. Queanbeyan-Palerang Regional Council holds the local plumbing regulator role here, under delegation from Building Commission NSW. Council also runs the local water network, and Bungendore and Braidwood each treat their own water. File that certificate with your property records.

Easy payment.
We tell you how to pay before we start, so there's no awkward moment at the end.
Out with the old. In with the right one.

Like-for-like swaps
The same type of unit, new and fitted.
- Electric tank for tank
- Wall unit for wall unit
- Old unit taken away
- Tested before we go

A size that fits now
A unit sized for the house you have today.
- Bigger families
- Fewer people at home
- Busy morning showers
- A change of type

Homes, rentals and shops
We swap the old unit, wherever it is.
- Family homes
- Rental properties
- Cafes and shops
- Units and townhouses
Other services
Common questions
Straight answers to what people ask us most.
Can't see your question? Call 0403 095 102
Can a heat pump keep up through a Ngunnawal winter?
According to the ACT Government, hot water heat pumps work well in the ACT’s cold climate, and they use 55 to 80% less energy than standard electric storage or gas hot water systems. Sizing still follows the household’s own use.
What can a Ngunnawal tenant do if the landlord can’t be reached about a dead hot water system?
If the lessor can’t be contacted or doesn’t fix an urgent problem within a reasonable time, an ACT tenant may arrange urgent repairs up to a maximum of 5% of the property’s rent over a year. Following the procedure strictly matters, since a tenant who doesn’t is personally liable for the cost.
Should I move stored items or equipment before quoting?
Describe the access first. Ordinary belongings may be moved safely, but do not disconnect equipment or alter fixed structures without an agreed plan.
Can I top up my Ngunnawal rainwater tank from the mains?
Only with an exemption. A property connected to Icon Water’s drinking water supply can fill or top up a tank from it only if Icon Water has granted an exemption. A tank connected to the main supply also needs a backflow prevention device.
Can I hand-water my Ngunnawal garden in the middle of a summer day?
You can. A hand-held hose fitted with a trigger nozzle, a bucket or a watering can may be used to water lawns and plants at any time, including the 9am to 6pm window when sprinklers are off.
I hold a concession card in Canberra. Is there help replacing my hot water system?
The ACT Home Energy Support Program offers eligible concession card owner-occupiers a rebate of 50% of supply and installation cost, up to $2,500, for a heat pump or evacuated tube solar system. A zero-interest loan of up to $10,000 is also available, subject to eligibility conditions. Do not accept a quote until the ACT Government has pre-approved your application.
How long will gas hot water be supported in Canberra?
The ACT plans to stop using fossil fuel gas by 2045. The ACT Government says the gas network may begin shutting down from the mid-2030s onwards. Until then, homes with an existing meter can keep using their connection.
Will the new unit be the same size as the old one?
Not always. We size it to how your house uses hot water now. The old unit is a starting point, not the answer.
Do you take the old unit away?
Yes. Taking the old unit out is part of the changeover, and it's listed in what we quote.
Do you replace units in rentals?
Yes. We quote for the owner or the property manager and sort out access with them.
How do I compare your quote with others?
Ours lists the unit, the fitting, taking the old one out and anything we still need to check. Line those up against the others.
Will the new unit be the same size as the old one?
Not always. We size it to how your house uses hot water now. The old unit is a starting point, not the answer.
Do you take the old unit away?
Yes. Taking the old unit out is part of the changeover, and it's listed in what we quote.
Do you replace units in rentals?
Yes. We quote for the owner or the property manager and sort out access with them.
How do I compare your quote with others?
Ours lists the unit, the fitting, taking the old one out and anything we still need to check. Line those up against the others.
Do you come out to Bungendore and Braidwood?
Yes. We cover Canberra and about 100 km around it.
Are you licensed?
Yes. ACT 20241513 and NSW 498011C, and fully insured.
Tell us what's wrong. We'll take it from there.
Send us a few details and we'll take it from there.
- Call us0403 095 102
- Email usoffice@oroflowplumbing.com





